This flowerpot was made from high-quality clay found under the wet topsoil of Pennsylvania's low-lying plains. Southeastern Pennsylvania's terrain could support farms on the topsoil and potteries on the subsoil, so by 1810 potteries could be found in almost every township in Buck's County.

The work of the potter fit into the agricultural calendar. The clay was dug in the fall: topsoil was cleared and a foot-deep layer of clay was sliced and shoveled into a wagon, hauled to the pottery, and stacked. Before freezing weather, the clay was carried in baskets and dumped into a mill - a round tub with a revolving post set with blades. A horse harnessed to a sweep walked slowly around the tub, turning the blades. Water was flushed through to clean the clay and the resulting mass of plastic earth turned gray to yellow. The clay was then shaped into one hundred pound blocks and stored in a cellar where it was kept moist but would not freeze.

This flowerpot started out as a flattened ball of clay. Thrown separately and then joined together, the pot and stand were formed by the potter on his wheel, which was rotated at variable speeds by the potter pushing a foot wheel, which in turn was connected to a balance wheel, allowing for smooth and continuous rotation. The surface is decorated with mottled red and yellow colored glazes, and the entire flowerpot is covered with a clear lead glaze.